H8/h7 fit — Locational clearance
ISO 286 hole-basis clearance fit. Enter a nominal size to get the limits.
Result
| Upper | Lower | Max | Min | Tol. | |
|---|---|---|---|---|---|
| Hole H8 | +0.033 | 0 | 25.033 | 25.000 | |
| Shaft h7 | 0 | −0.021 | 25.000 | 24.979 |
- Max clearance
- 0.054 mm
- Min clearance
- 0.000 mm
- Mean
- +0.027 mm
Fit diagram (µm · zero line = nominal)
About H8/h7
Parts that slide or can be assembled by hand and are located by other means; slightly looser than H7/h6.
At Ø25 mm the hole H8 measures 0 mm to +0.033 mm and the shaft h7 −0.021 mm to 0 mm, giving a clearance of 0.000 mm to 0.054 mm.
How the limits are calculated
Hole H8: fundamental deviation EI = 0, standard tolerance IT8 = 33 µm for 18–30 mm. Shaft h7: fundamental deviation es = 0, IT7 = 21 µm. Clearance = hole − shaft, evaluated at both extremes. Values per ISO 286-1:2010.
H8/h7 limits by size range
| Size (mm) | Hole H8 | Shaft h7 | Clearance min | Clearance max |
|---|---|---|---|---|
| ≤ 3 | +0.014 / 0 | 0 / −0.010 | 0 | +0.024 |
| 3 – 6 | +0.018 / 0 | 0 / −0.012 | 0 | +0.030 |
| 6 – 10 | +0.022 / 0 | 0 / −0.015 | 0 | +0.037 |
| 10 – 18 | +0.027 / 0 | 0 / −0.018 | 0 | +0.045 |
| 18 – 30 | +0.033 / 0 | 0 / −0.021 | 0 | +0.054 |
| 30 – 50 | +0.039 / 0 | 0 / −0.025 | 0 | +0.064 |
| 50 – 80 | +0.046 / 0 | 0 / −0.030 | 0 | +0.076 |
| 80 – 120 | +0.054 / 0 | 0 / −0.035 | 0 | +0.089 |
| 120 – 180 | +0.063 / 0 | 0 / −0.040 | 0 | +0.103 |
| 180 – 250 | +0.072 / 0 | 0 / −0.046 | 0 | +0.118 |
| 250 – 315 | +0.081 / 0 | 0 / −0.052 | 0 | +0.133 |
| 315 – 400 | +0.089 / 0 | 0 / −0.057 | 0 | +0.146 |
| 400 – 500 | +0.097 / 0 | 0 / −0.063 | 0 | +0.160 |
Deviations in mm at the upper end of each range; negative clearance = interference. Clearance columns are shown on wider screens. Sub-ranges (e.g. 18–24 / 24–30) can differ for r, s, t, u, v, x, y, z — use the calculator for the exact size.